MinkaAire Rainman Instruction Manual

INSTRUCTION MANUAL WARRANTY CERTIFICATETMRainmanBYU.S. Patent: D460,549

4 WARNING: All of the parts, hardware and components such as the hanger bracket and hanger ball have been provided for your safety and the pro

Fig. 5Fig. 7 Fig. 8Fig. 6Fig. 10Fig. 9CANOPY COVEROUTLET BOXHANGER BRACKETDOWNRODSUPPLYWIRESREGISTRATIONSLOTCROSS PINHANGERBALLDOWNRODHITCHPINLOCKPINS

5 WARNING: To avoid possible electrical shock be sure electricity is turned off at the main fuse or breaker box before wiring. NOTE: The Aire Con

Step 3. Receiver to House Supply Wires Electrical Connections: Connect the WHITE wire (Neutral) from the outlet box to the WHITE wire marked "AC

Fig. 13Fig. 14WALLCONTROLBLACKBLACKBLACKBLACKBLACKWHITEBLUEBLUEGROUNDGROUNDORANGEGREENINPUTAC120VAC SUPPLYWHITE (NEUTRAL)WHITE (NEUTRAL)GREEN OR BAREC

6Fig. 15WARNING! HOOK UP "IN SERIES" ONLY. DO NOT CONNECT NEUTRAL SUPPLY WIRE OF ELECTRIC CIRCUIT TO THE TRANSMITTER WALL SWITCH, DAMAGE TO

7Step 1. Tuck connections neatly into ceiling outlet box.Step 2. Slide the canopy up to ceiling and over the two screws on hanger bracket. Rotate cano

8Fig 17THE FOLLOWING OPERATIONS MUST BE ACCOMPLISHED BEFORE INSTALLING THE LIGHT KIT.Insert one fan blade into the blade slot on the motor housing and

Fig 189INSTALLING THE LIGHT KIT REMEMBER to disconnect the power. The fan blades must already be attached to the fan.ATTENTION: The Energ

Fig. 20Fig. 19Step 3. (Fig.19) Place the Glass Shade into the glass frame and secure with three screws.Step 4. (Fig. 20) Install 1x100W halogen bulb (

This product is protected by United States Federal and/or State Law, including Patent, Trademark and/or Copyright laws.Manual design and all elements

10OPERATING THE REMOTE CONTROL/WALL TRANSMITTERRestore Power to Ceiling Fan.A. Buttons: These buttons are used to set the fan speeds a

Fig 21Fig 22Speed settings for warm or cold weather depend on factors such as room size, ceiling height and number of fans.NOTE: Wait for fan to sto

11 Here are some suggestions to help maintain your fan.1. Because of the fan's natural movement some connections may become loose. C

12TROUBLESHOOTINGSYMPTOM Fan will not start Check to make sure the wall switch is turned on.Check circuit fuses or breakers.Caution! Make sure the

SYMPTOM Fan WobbleNOTE: All blade sets are grouped by weight. Because wood and plastic blades vary in density, the fan may wobble even though blades

SYMPTOM Frequency InterferenceTurn the power off to your ceiling fan.Please use a small size tool to change the frequency settings on the control sys

13RPMCFMN.W. G.W. C.F.54"120120120Fan Size Speed Volts Amps WattsLow MediumHighSPECIFICATIONSThese are typical readings. Your actual fan may vary

Minka-Aire warrants to the original owner that this fan will be free from defects in material an

Date Purchased Store Purchased Model Number S

CONTENTSBLADE INSTALLATION...INSTALLING THE LIGHT KIT ...

SAFETY RULES1 1. Before you begin installing the fan, shut power off at the circuit breaker of the fuse box. 2. Be cautious! Read all inst

WARNINGTO REDUCE THE RISK OF FIRE, ELECTRIC SHOCK OR OTHER PERSONAL INJURY, MOUNT FAN ONLY TO A U.L. LISTED OUTLET BOX OR SUPPORTING SYSTEM MARKED ACC

21. Fan blades (5)2. Hanger bracket 3. Canopy4. Canopy cover5a. Standard downrod assembly 5b. Minimum-length downrod (for close to ceil

3Tools Required: Phillips screw driver; slotted screw driver; step-ladder; wire cutters; electrical tape. INSTALLING THE FANMOUNTING OPTIONSIf there